Armchair of chrome-plated, square hollow steel frame and yellow vinyl upholstered seat and back cushion. The back and seat of the chair are a continuous, rectangular unit made of wood covered in vinyl and bent to support human body; seam in upholstery where seat and back meet; seat is sprung. This unit is supported by the metal frame: straight arms start midway down the side of the chair back then curve down to form the front legs; a horizontal seat rail joins the legs. Welded to the back of each front leg at the middle, a single piece extends back along the underside of the seat along the outer edge (supporting the seat), then curves downward to form shorter, angled rear leg. Tubular steel stretcher spans rear legs. Rectangular metal frame inset under seat. CONDITION: Frame with minor pitting throughout, especially where sitter's hands touch. Scratches throughout, especially lower legs. Joints and corners dirty with minor corrosion. Inset frame unfinished except for exposed parts, worn. Vinyl upholstery on back and joints: small pen mark to front proper left of back.